Owners Manual

6. Place the heat sink on the processor and push down until the bracket locks onto the heat sink.

NOTE:

● Ensure that the two guide pin holes on the bracket match the guide holes on the heat sink.

● Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the bracket before placing the

heat sink on the processor and bracket.

Figure 35. Installing the heat sink onto the processor

Next steps

1. Install the processor and heat sink module.

2. Follow the procedure listed in After working inside your system.

Removing the non-fabric processor from the processor and heat

sink module

Prerequisites

NOTE:

Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink.

This procedure is not required when replacing a system board.

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the air shroud.

4. Remove the processor and heat sink module.

Steps

1. Place the heat sink with the processor side facing up.

2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break

the thermal paste seal.

3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.

Installing and removing enclosure components