Owners Manual

Figure 45. Removing the expansion card riser assembly

Next steps

1. Install the expansion card riser assembly.

Installing the expansion card riser assembly

Prerequisites

NOTE:

You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications

Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper

cooling and airflow inside the system.

1. Follow the safety guidelines listed in Safety instructions..

Steps

1. Place the expansion card assembly into the system board assembly.

2. Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into

place.

3. Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly.

Figure 46. Installing the expansion card riser assembly

Installing and removing enclosure components