CLI Guide

Table Of Contents
Firmware version 4.30.30.30
Following features were added in this release:
Added support for PCIe Gen 4 NVMe drives with PERC 11
Added support for infinibandstatistics command
Added support for sd option for virtual disk encryption
Added support for additional controller properties such as - AutoConfigBehavior, in racadm storage get
<controller> output
Added support for additional physical disk properties such as - Certified, NonRAIDDiskCachePolicy and,
EncryptionProtocol in racadm storage get <pdisk> output
Added support for stacking controller local key management (LKM) setting and creating secure virtual disk using one target
config job
Added support for BOSS-S2 controllers. These controllers also support LED blink and unblink along with hot plugging M.2
drives
Firmware version 4.20.20.20
Following features were added in this release:
Added support for inventory of PCIe Gen 4 NVMe drives with data transfer speeds up to 16 GTs
Added support for secure erase and prepare to remove features for PCIe SSDs
Added support for OEM power supply units
Firmware version 4.10.10.10
Following features were added in this release:
Added support for biosscan command
Added support for infiniband systems management
Added PCI Express Generation property in the get command output of storage enclosure device
Firmware version 4.00.00.00
Following features were added in this release:
The default prompt from SSH to iDRAC is now racadm>>
Added support for httpsbootcert command
Added support for networktransceiverstatistics command
Added support for testrsyslogconnection command
Added support for serialcapture command
Added support for Dell EMC OpenManage Secure Enterprise Key Manager with the new SEKM subcommand
Added support for remote / programmatic support for HTTPS Cert Management
Added support for SFP transceiver inventory via iDRAC
Added support for enhanced commands to support HTTP/HTTPS/FTP/TFTP share types
Added support for enhanced GPU management
Added support for streaming telemetry data from iDRAC
Added support for retrieving telemetry data from SupportAssist
cd.. command changed to cd ..
Added racadm error codes
Deprecated and New Subcommands
NOTE:
Following commands are deprecated, and will not be available from iDRAC version 4.40.00.00 and onwards. You must
reconfigure the scripts that use these commands to avoid any issues or failures.
Introduction 13