Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6420 Installation and Service Manual
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Figure 23. Removing a memory module
Next steps
1. Install the memory module.
CAUTION: If you are removing the memory module permanently, install a memory module blank. The
procedure to install a memory module blank is similar to that of the memory module.
Installing a memory module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Locate the appropriate memory module socket.
CAUTION:
Handle each memory module only by the edges, ensuring not to touch the middle of the memory
module or metallic contacts.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do
not bend or flex the memory module. You must insert both ends of the memory module simultaneously.
2. Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the
memory module evenly.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
4. Press the memory module with your thumbs until the socket levers firmly click into place.
34
Installing and removing enclosure components