Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6420 Installation and Service Manual
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Figure 60. Installing the M.2 SATA x16 riser
Next steps
1. Install the sled into the enclosure.
2. Follow the procedure listed in After working inside your system.
Removing the M.2 SATA card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions..
2. Follow the procedure listed in Before working inside your system.
3. Remove the sled from the enclosure.
4. If applicable, remove the expansion card riser assembly.
5. Remove the M.2 x16 riser or the M.2 SATA x8 mezzanine card.
NOTE: The procedure to remove the M.2 SATA x8 mezzanine card is similar to removing a mezzanine card.
Steps
1. Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.
2. Pull the card out of the connector and lift the card away.
68
Installing and removing enclosure components