Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6420 Installation and Service Manual
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Figure 65. Removing a mezzanine card
Next steps
1. Install the mezzanine card or install the mezzanine card filler bracket.
Installing a mezzanine card
Prerequisites
NOTE: The procedure to install the mezzanine blank is similar to the removal of a mezzanine card.
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Attach and secure the mezzanine card bracket to the mezzanine card.
2. Holding the card by its edges, position the card so that the card edge connector aligns with the connector of the bridge
board on the system board.
3. Insert the card edge connector and push the card firmly until the card is fully seated on the bridge board.
72
Installing and removing enclosure components