Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6420 Installation and Service Manual
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
4. Using the Phillips #2 screwdriver, secure the mezzanine card and bracket assembly to the sled using screws.
Figure 66. Installing a mezzanine card
Next steps
1. Install the mezzanine card or install the mezzanine card filler bracket.
2. Install the expansion card riser assembly
3. Follow the procedure listed in After working inside your system.
Removing the mezzanine card bridge board
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card riser assembly
4. Remove the mezzanine card.
Installing and removing enclosure components
73