Owners Manual
Table Of Contents
- Dell EMC PowerEdge C6420 Installation and Service Manual
- Dell EMC PowerEdge C6420 overview
- Initial system setup and configuration
- Installing and removing enclosure components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Dell EMC PowerEdge C6420 sled
- PERC battery
- Air shroud
- System memory
- Support bracket
- Linking board and PCIe cable
- Processor and heat sink module
- Removing a processor and heat sink module
- Installing a processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non-fabric processor from the processor and heat sink module
- Installing the non-fabric processor into a processor and heat sink module
- Removing the fabric and sideband cables
- Installing the fabric and sideband cables
- Expansion cards
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the M.2 SATA x16 riser
- Installing the M.2 SATA x16 riser
- Removing the M.2 SATA card
- Installing the M.2 SATA card
- M.2 SSD module
- Mezzanine and OCP cards
- System battery
- System board
- Trusted Platform Module
- System diagnostics
- Jumpers and connectors
- Getting help
- Documentation resources
Figure 72. Installing the system battery
Next steps
1. If removed, install the expansion card riser.
2. Follow the procedure listed in After working inside your system.
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
System board
Removing the system board
Prerequisites
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in
module is installed, it is cryptographically bound to that specific system board. Any attempt to remove an
installed TPM plug-in module breaks the cryptographic binding, and it cannot be reinstalled or installed on
another system board.
CAUTION: To avoid damage to the system board, ensure that the system board does not touch the side walls of
the sled chassis, while sliding the system board into the sled.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the sled from the chassis.
4. Remove the air shroud.
5. Remove the expansion card risers.
6. Remove the processor heat sink module.
7. Remove the memory modules.
8. If installed, remove OCP card.
9. If installed, remove the mezzanine card.
10. Remove the linking board
11. Disconnect all the cables from the system board.
12. Keep the Phillips #1 screwdriver and #4 nut driver ready.
Steps
1. Remove the screws that secure the system board to the sled assembly.
CAUTION:
Do not lift the system board by holding a memory module slot, any other connector, or
component.
2. Hold the system board by the edges, and lift the system board away from the sled.
78
Installing and removing enclosure components