Reference Guide

Table 19. Gaseous contamination specifications

Gaseous contamination Specifications

Copper coupon corrosion rate <300 Å/month per Class G1 as defined by ANSI/ISA71.04-2013

Silver coupon corrosion rate <200 Å/month per Class G1 as defined by ANSI/ISA71.04-2013

NOTE: Maximum corrosive contaminant levels measured at ≤50% relative humidity.

Maximum vibration specifications

Table 20. Maximum vibration specifications

Maximum vibration Specifications

Operating 0.26 Grms at 5 Hz to 350 Hz (all operation orientations).

Storage 1.88 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested).

Maximum shock specifications

Table 21. Maximum shock specifications

Maximum shock Specifications

Operating 24 executed shock pulses 6 G in the positive and negative x, y, z

axis for up to 11 ms (four pulses on each side of the system).

Storage Six consecutively executed shock pulses of 71 G in the positive and

negative x, y, z axes for up to 2 ms (one pulse on each side of the

system).

Maximum altitude specifications

Table 22. Maximum altitude specifications

Maximum altitude Specifications

Operating 3048 m (10,000 ft)

Storage 12,000 m (39,370 ft)

Fresh Air Operation

Fresh Air operation restrictions

• Processors with a TDP greater than 105 W are not supported

• Support for processors of 85 W and below without PERC restrictions

• 3.5-inch drive configuration is not supported

• 114-mm heat sink is required for the processor in CPU1 socket

• Kerby-flat OCP is not supported

• M.2 card on DCS Mezzanine slot is not supported.

• NVMe SSD is not supported

• AEP DIMM and LRDIMM are not supported

• PCIe cards greater than 25 W are not supported

• H730 PERC and H330 support for 105-W processors

Technical specifications