CLI Guide

Table Of Contents
FCoE Link Failures: Not Applicable
Lan Unicast Packets Received: 0
Lan Unicast Packets Transmitted: 0
Lan FCS Receive Errors: Not Applicable
Partition Link Status: Down
Partition Driver State: Operational
Total RDMA Packets Received: 0
Total RDMA Packets Transmitted: 0
Total RDMA Bytes Transmitted: 0
Total RDMA Bytes Received: 0
Total RDMA Transmitted ReadRequest Packets: Not Applicable
Total RDMA Transmitted Send Packets: Not Applicable
Total RDMA Transmitted Write Packets: Not Applicable
Total RDMA Protocol Errors: Not Applicable
Total RDMA Protection Errors: Not Applicable
NOTE: When Port, Partition or RDMA statistics are not available, the output displays No Port/Partition/RDMA
Statistics found for FQDD <NIC FQDD>.
To get the network statistics, type the following command:
racadm nicstatistics
NIC.Integrated.1-1-1:QLogic 2x25GE QL41232HQCU NIC - 34:80:0D:2A:D9:E0
PartitionCapable : 1
NIC.Integrated.1-1-2:QLogic 2x25GE QL41232HQCU NIC - 34:80:0D:2A:D9:E2
PartitionCapable : 2
NIC.Integrated.1-1-3:QLogic 2x25GE QL41232HQCU NIC - 34:80:0D:2A:D9:E4
PartitionCapable : 3
NIC.Integrated.1-1-4:QLogic 2x25GE QL41232HQCU NIC - 34:80:0D:2A:D9:E6
PartitionCapable : 4
ping
Table 77. Details of ping
Description Verifies if the destination IP address is reachable from iDRAC with the current routing-table contents. A
destination IP address is required. Based on the current routing-table contents, an ICMP echo packet is
sent to the destination IP address.
To run this subcommand, you must have the Debug privilege.
Synopsis
racadm ping <ipaddress>
Input <ipaddress> The IP address of the remote endpoint to ping.
Output
PING 192.168.0 (192.168.0): 56 data bytes64 bytes from 192.168.0: seq=0
ttl=64 time=4.121 ms
192.168.0 ping statistics
1 packets transmitted, 1 packets received, 0 percent packet lossround-
trip min/avg/max = 4.121/4.121/4.121 ms
ping6
Table 78. Details of ping6
Description
Verifies if the destination IPv6 address is reachable from iDRAC or with the current routing-table
contents. A destination IPv6 address is required. Based on the current routing-table contents, an ICMP
echo packet is sent to the destination IPv6 address.
RACADM Subcommand Details 105