Owner's Manual

156 Installing System Components

Installing a Sled

Orient the sled so that the release latch is in the bottom of the sled. See

Figure 3-6.

Slide the new sled into the enclosure until the sled is fully seated and the

release latch snaps into place. See Figure 3-6.

Sled Blank

CAUTION: To ensure proper airflow in the system, if a module is removed it

should be immediately replaced with another sled or sled blank.

The information in this section include replacement procedures for the

double-wide and single-wide sled blank.

Removing a Double-Wide Sled Blank

Squeeze and hold the release latches and slide the blank out of the enclosure.

See Figure 3-7.

Figure 3-7. Removing and Installing a Double-Wide Sled Blank

1 release latches (2) 2 double-wide sled blank