Owners Manual

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Remove the two screws that secure the LOM riser card to the system board.
2. Lift the card from the system board.
Figure 23. Removing the LOM riser card
1.
LOM riser card 2. screw (2)
3. standoff (2) 4. connector on the system board
Next steps
1. Install the LOM riser card.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 48
Installing the LOM riser card on page 75
After working inside your system on page 49
Installing the LOM riser card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
Installing and removing sled components 75