Owners Manual

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the LOM riser card to replace a faulty LOM riser card or service other components inside the
system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Align the screw holes on the card with the standoffs on the system board.
CAUTION: To prevent damage to the LOM riser card, you must hold the card only by its edges.
2. Press the card into place until the card connector fits into the corresponding connector on the system board.
3. Secure the card with the two screws.
Figure 24. Installing the LOM riser card
1.
LOM riser card 2. screw (2)
3. standoff (2) 4. connector on the system board
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 48
After working inside your system on page 49
Removing the LOM riser card on page 74
76
Installing and removing sled components