Owners Manual

If you need to service an SSD, no sled shutdown or power-off is needed before removing the SSD. The PowerEdge FC430
system supports up to two 1.8 inch uSATA SSDs, supplied in special hot-swap drive carriers.
Removing an SSD from an SSD carrier
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Remove the SSD carrier out of the sled.
Steps
Pull the rails on the side of the carrier and lift the SSD out of the carrier.
Results
Figure 31. Removing an SSD in an SSD carrier
1. SSD carrier
2. SSD
Next steps
1. Install an SSD in the SSD carrier.
2. Install the SSD carrier into the sled.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 48
Removing an SSD carrier on page 89
Installing an SSD into an SSD carrier on page 88
After working inside your system on page 49
Installing and removing sled components
87