Owners Manual

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #1 screwdriver ready.
Steps
1. Align the slots on the sides of the SSD cage with the guide pins on the chassis.
2. Push the SSD cage into the chassis until the screw holes on the chassis are aligned with the holes on the SSD cage.
3. Slide the SSD cage into the chassis till the IDSDM card connector engages completely with the connector on the system
board.
4. Secure the SSD cage to the chassis with the screws.
Figure 38. Installing the SSD cage
1.
chassis 2. guide pin slot (4)
3. SSD cage 4. screw (4)
5. guide pin (4)
Next steps
1. Install the SSD backplane.
2. Install the SSDs.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 48
Installing the SSD backplane on page 96
Installing an SSD carrier on page 90
After working inside your system on page 49
Removing the SSD cage on page 92
94
Installing and removing sled components