Owners Manual

Figure 6. Removing the sled
a. sled handle
b. sled
c. FX2/FX2s enclosure
Related references
Safety instructions on page 48
Related tasks
Installing the sled on page 50
Before working inside your system on page 48
After working inside your system on page 49
Installing the sled
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To prevent damage to the I/O connectors, do not touch connectors or the connector pins.
NOTE: Before installing the sleds, place the chassis in the location that you want.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. If you are installing a new sled, remove the plastic cover from the I/O connector(s) and save for future use.
2. Press the release button on the sled handle to the open position.
3. Align the sled with the bay on the enclosure.
4. Slide the sled into the enclosure until the sled connectors are firmly engaged with the midplane connectors.
The sled handle rotates toward the enclosure as the sled slides into the enclosure.
5. Press the sled handle to closed position until the release button clicks into place.
50
Installing and removing sled components