Owners Manual

Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad on page 50
Related tasks
Before working inside your system on page 51
Removing a hard drive or SSD blank on page 102
Después de trabajar en el interior de su equipo on page 51
Procedimiento de apagado para reparar una unidad de disco duro o
SSD
NOTA: Esta sección solo se aplica a situaciones cuando debe apagarse el sled para reparar una unidad de disco duro o SSD.
Si necesita reparar una unidad de disco duro o SSD, apague el sled y, antes de quitar la unidad de disco duro o SSD, espere
30 segundos una vez que el indicador del sled se apague. De lo contrario, la unidad de disco duro o SSD podría no reconocerse
tras su reinstalación y el sled se encenderá nuevamente.
Configuración de la unidad de inicio
La unidad o el dispositivo desde el que se inicia el sistema está determinado por la secuencia de inicio especificada en System
Setup (Configuración del sistema).
Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive
or SSD carrier
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #1 screwdriver ready.
Steps
1. Remove the four screws from the slide rails on the hard drive or SSD carrier.
2. Slide the hard drive or SSD out of the hard drive or SSD carrier.
Instalación y extracción de componentes del sled
105