Owners Manual

2. Loosen the retention screws securing the hard-drive or SSD backplane to the hard-drive or SSD cage.
3. Lift the hard-drive or SSD backplane by its edges until the retention screws disengage from the screw holes on the hard-
drive or SSD cage.
4. Remove the hard-drive or SSD cage.
5. Loosen the retention screws securing the hard-drive or SSD backplane cable connector to the system board connector.
6. Lift the backplane away from the system.
Figure 55. Removing a 2.5-inch (x8) SATA hard-drive or SSD backplane
1.
alignment pin (2) 2. power cable
3. retention screw on the top of the hard-drive or SSD
backplane (4)
4. hard-drive or SSD backplane
5. hard-drive or SSD backplane cable connector 6. hard-drive or SSD backplane cable
7. retention screw on the bottom of the hard-drive or SSD
backplane (4)
8. screw holes on the hard-drive or SSD cage (6)
Next steps
1. Install the hard-drive or SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad on page 50
Related tasks
Before working inside your system on page 51
Installing a 2.5-inch (x8) SATA hard-drive or SSD backplane on page 114
Después de trabajar en el interior de su equipo on page 51
Instalación y extracción de componentes del sled
113