Owners Manual

Next steps
1. Install the hard-drive or SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad on page 50
Related tasks
Before working inside your system on page 51
Installing a 2.5-inch (x6) SATA hard drive or SSD and 2.5-inch (x2) PCIe SSD backplane on page 120
Después de trabajar en el interior de su equipo on page 51
Installing a 2.5-inch (x6) SATA hard drive or SSD and 2.5-inch (x2)
PCIe SSD backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the hard-drive or SSD backplane.
NOTE:
You must remove the hard-drive or SSD backplane to replace a faulty hard-drive or SSD backplane or service
other components inside the system.
Steps
1. Align the retention screws on the SATA hard-drive or SSD backplane cable connector with the screw holes on the system
board connector (SATA_BP).
2. Tighten the two retention screws to secure the hard-drive or SSD backplane cable connector on the system board.
3. Perform the following steps:
a. Route the SATA hard-drive or SSD backplane cable through the retention clip on the chassis and close the retention clip.
b. Lower the SATA hard-drive or SSD backplane cable into the chassis until the slot on the cable engages with the standoff
on the chassis.
4. Align the retention screws on the PCIe SSD backplane cable connector with the screw holes on the system board connector
(J_PERC).
5. Tighten the two retention screws to secure the PCIe SSD backplane cable connector on the system board.
6. Install the hard drive or SSD cage.
7. Align the retention screws on the hard-drive or SSD backplane with the screw holes on the hard drive or SSD cage.
8. Lower the hard-drive or SSD backplane into place until the retention screws on the hard-drive or SSD backplane engage
with the screw holes on the hard-drive or SSD cage.
9. Tighten the retention screws to secure the hard-drive or SSD backplane on the system board.
10. Connect the power cable to the backplane.
120
Instalación y extracción de componentes del sled