Owners Manual

3. Socket del procesador 4. Ranura del tornillo de retención (4)
Siguientes pasos
1. Siga el procedimiento que se describe en la sección Después de trabajar en el interior del sistema.
2. Mientras se inicia, presione <F2> para abrir System Setup (Configuración del sistema) y compruebe que la información del
procesador corresponda con la nueva configuración del sistema.
3. Ejecute los diagnósticos del sistema para verificar que el nuevo procesador funciona correctamente.
Referencias relacionadas
Instrucciones de seguridad on page 50
Tareas relacionadas
Before working inside your system on page 51
Instalación de un procesador on page 77
Después de trabajar en el interior de su equipo on page 51
Tarjeta intermedia PCIe
El sistema admite tarjetas intermedias x16 Gen 3 PCIe, que ofrecen una interfaz entre el sled y los conmutadores PCIe en el
gabinete FX2s.
NOTA:
Asegúrese de que la tarjeta intermedia PCIe esté establecida como Enabled (Activado) en System Setup (Programa
de configuración del sistema).
Removing a PCIe mezzanine card
Prerequisites
CAUTION:
Muchas de las reparaciones deben ser realizadas únicamente por un técnico de servicio autorizado. El
usuario debe llevar a cabo únicamente las tareas de solución de problemas y las reparaciones sencillas
autorizadas en la documentación del producto o indicadas por el personal de servicio y de asistencia en línea o
telefónica. Los daños causados por reparaciones no autorizadas por Dell no están cubiertos por la garantía. Lea y
siga las instrucciones de seguridad que se envían con el producto.
NOTE: You must remove the PCIe mezzanine card to replace a faulty PCIe mezzanine card or service other components
inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Open the PCIe mezzanine card retention latch by pressing the release tab on the retention latch.
2. Pull back and hold the retention bracket away from the PCIe mezzanine card.
3. Lift the end of the retention latch until the two connectors on the PCIe mezzanine card disengage from connectors on the
system board.
CAUTION: To prevent damage to the PCIe mezzanine card, hold the card only by its edges.
4. Lift the PCIe mezzanine card away from the system.
5. Close the retention latch.
80
Instalación y extracción de componentes del sled