Owners Manual

Ilustración 29. Instalación de la llave de memoria USB interna

a. Unidad de memoria USB

b. Puerto USB

Siguientes pasos

1. Siga el procedimiento que se describe en la sección Después de trabajar en el interior del sistema.

2. Al iniciar el sistema, presione F2 para entrar en System Setup (Configuración del sistema) y compruebe que el sistema

detecte la llave de memoria USB.

Removing the IDSDM card

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the system.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your system section.

3. Keep the #2 Phillips screwdriver ready.

4. If installed, remove the internal USB key.

5. If installed, remove the SD card(s).

Steps

1. Remove the two screws securing the IDSDM card to the system board.

2. Remove the SD card slot bracket.

CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.

3. Lift the card away from the system.

Instalación y extracción de componentes del sled