Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Back panel features and indicators—PowerEdge FX2s
and FX2
Figure 7. Back panel features and indicators—PowerEdge FX2s
Figure 8. Back panel features and indicators—PowerEdge FX2
Table 4. Back panel features and indicators—PowerEdge FX2 and PowerEdge FX2s enclosures
Item Indicator, Button, or Connector Description
1 Serial connector DB-9 serial connector for CMC configuration.
2 Ethernet connector Gb1 Connects the network cable from the management system to the CMC.
3 Ethernet connector STK/Gb2
(stack)
Used for daisy-chaining CMCs in separate enclosures.
NOTE: This port can also be used for CMC NIC failover.
4 System identification button The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the system status indicator on the back flashes until one of the
buttons is pressed again.
Press to toggle the system ID on and off.
5 Low-profile PCIe expansion slots
(8)
Enable you to connect up to eight low-profile PCIe expansion cards.
NOTE: PowerEdge FX2 does not support PCIe expansion slots and
has a filler panel.
6 Power supply unit (PSU1) 1100 W (1050 W for low line)
About your Dell PowerEdge FX2/FX2s 11