Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
System cover
Removing the system cover
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: To ensure proper operation and cooling, replace the system cover within three minutes of removal.
1. Ensure that you read the Safety instructions on page 33.
2. Follow the procedure listed in Before working inside your system on page 33.
Steps
1. Rotate the cover lock counterclockwise to the unlock position.
2. Press the release latches on both sides of the system toward the cover lock.
3. Slide the cover toward the front of the system and lift the cover away from the system.
Figure 31. Removing and installing the system cover
a. release latch (2)
b. system cover
c. cover lock
Next steps
Install the system cover.
Related tasks
Installing the system cover on page 35
34
Installing and removing PowerEdge FX2/FX2s enclosure components