Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Figure 51. Removing and installing the bottom partition
a. bottom partition
b. screw (2)
6. Remove the two screws that secure the bottom interposer module to the top of the system.
7. Pull out the bottom interposer module from the system.
Figure 52. Removing and installing the bottom interposer module
a. bottom interposer module (2)
b. screw (2)
Next steps
Install the bottom interposer module.
Related tasks
Installing the bottom interposer module on page 64
Removing a compute sled on page 35
Removing a storage sled on page 37
Removing a power supply unit on page 50
Removing the CMC module on page 42
Installing and removing PowerEdge FX2/FX2s enclosure components
63