Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Figure 60. Routing of the KVM and control panel cables on the midplane
1.
KVM cable connector 2. KVM cable
3. brackets on the midplane assembly to route the KVM cable4. control panel cable
5. brackets on the midplane assembly to route the control
panel cable
6. control panel cable connector
7. connector on the midplane
14. Lift the midplane assembly out of the system.
Next steps
1. Install the midplane assembly.
Related tasks
Installing the midplane assembly on page 73
Removing a compute sled on page 35
Removing a storage sled on page 37
Removing a power supply unit on page 50
Removing the CMC module on page 42
Removing an I/O module on page 44
Removing the system cover on page 34
Removing a cooling fan on page 52
Removing the cooling-fan cage on page 54
Removing a PCIe module on page 45
Removing the PCIe switch board on page 56
Removing the fan interface board on page 58
Removing the bottom interposer module on page 61
Removing the top interposer module on page 65
72
Installing and removing PowerEdge FX2/FX2s enclosure components