Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
3. connector 4. KVM panel
5. KVM panel cover
Next steps
Install the KVM panel.
Related tasks
Installing the KVM panel on page 79
Installing the KVM panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified
service technicians.
1. Ensure that you read the Safety instructions on page 33.
2. Follow the procedure listed in Before working inside your system on page 33.
3. Remove the KVM panel.
NOTE: You must remove the KVM panel to replace a faulty panel.
Steps
1. Connect the KVM panel cable to the KVM panel.
2. Press the connector latch into place.
3. Install the screw to secure the KVM panel cover to the KVM panel.
4. Align the screw holes on the KVM panel with the screw holes on the side of the system.
5. Install the two screws to secure the KVM panel to the side of the system.
6. Insert the KVM panel cable in the cable tube.
7. Align the screw holes on the cable tube with the screw holes on the side of the system.
8. Install the three screws to secure the cable tube to the side of the system.
Next steps
Follow the procedure listed in After working inside your system on page 33.
Related information
Removing the KVM panel on page 77
Installing and removing PowerEdge FX2/FX2s enclosure components
79