Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Compute
sleds
Specifications
Up to four PowerEdge FC430 compute sleds mixed with up to two PowerEdge FC630/FC640 compute
sleds, or
One PowerEdge FC830 compute sled mixed with up to two PowerEdge FC630/FC640 compute sleds
Storage sleds Specifications
PowerEdge FX2s
Up to three PowerEdge FD332 storage sleds mapped to one PowerEdge FC630/FC640 compute sled, or
Up to two PowerEdge FD332 storage sleds mapped to two PowerEdge FC630/FC640 compute sleds, or
Up to two PowerEdge FD332 storage sleds mapped to up to four PowerEdge FC430 compute sleds, or
Up to two PowerEdge FD332 storage sleds mapped to one PowerEdge FC830 compute sled
NOTE: For more information on the technical specifications for the compute and storage sled(s), see the relevant sled
Owner's Manual at Dell.com/poweredgemanuals.
NOTE: For information on mapping of storage sleds to compute sleds in the PowerEdge FX2s enclosure, see the Dell
PowerEdge FD332 Owner's Manual at Dell.com/poweredgemanuals.
Power specifications
Power supply
unit
Specifications
Wattage 1100 W (1050 W for low line)
1600 W (800 W for low line)
2000 W (1000 W for low line)
2400 W (1400 W for low line)
Connector Card Edge
Heat dissipation 394 BTU/hr (full load for the power supply unit only) (1100 W power supply unit)
475 BTU/hr (full load for the power supply unit only) (1600 W power supply unit)
635 BTU/hr (full load for the power supply unit only) (2000 W power supply unit)
760 BTU/hr (full load for the power supply unit only) (2400 W power supply unit)
Maximum inrush
current
25 A
System voltage
requirements
100 – 240 V AC
NOTE: This system is also designed to be connected to IT power systems with a phase to phase
voltage not exceeding 230 V.
Chassis Management Controller (CMC) specifications
Externally
accessible
connectors
Specifications
Remote
management
Two dedicated 10/100/1000 Mb RJ-45 (for integrated Ethernet remote access controller). Gb port
connects to the CMC module’s external management network. STK port allows CMCs in adjacent
enclosures to be daisy chained. The STK port can also be used for CMC NIC failover.
Serial 9-pin, DTE, 16550-compatible
86 Technical specifications—PowerEdge FX2/FX2s