Owners Manual

NOTE: You must remove the cooling shroud retention bar to replace a faulty retention bar or service other components
inside the system.
5. Ensure that the memory module socket ejectors are in the locked position.
Steps
1. Lower the cooling shroud retention bar into the system until the screw holes on the cooling shroud retention bar align with
the screw holes on the chassis.
2. Install the screws to secure the cooling shroud retention bar to the system.
Figure 12. Installing the cooling shroud retention bar
a. screw (9)
b. cooling shroud retention bar
c. standoff (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system on page 48
Installing the sled on page 50
Removing the cooling shroud retention bar on page 55
After working inside your system on page 49
Installing and removing sled components
57