CLI Guide

• 1 (100 MBit)
• 2 (1000 MBit)
NOTE: You cannot manually set the Network Speed to 1000 MBit. This option is available only if
cfgNetTuningNicAutoNeg is set to 1 (Enabled).
Default
1
cfgNetTuningNicFullDuplex (Read or Write)
Table 354. Details of cfgNetTuningNicFullDuplex attribute
Description
Specifies the duplex setting for the NIC. This property is used only if thecfgNetTuningNicAutoNeg is set to 0
(disabled).
Legal Values
• 0 (Half Duplex)
• 1 (Full Duplex)
Default
1
cfgNetTuningNicMtu (Read or Write)
Table 355. Details of cfgNetTuningNicMtu attribute
Description
Indicated the maximum size of units in bytes transmitted by NIC.
Legal Values
576–1500
Default
1500
NOTE: IPv6 requires a minimum MTU of 1280. If IPv6 is enabled, and cfgNetTuningMtu is set to a lower value, the
CMC uses an MTU of 1280.
cfgSensorRedundancy
This group is used to set the power supply redundancy.
The following sections provide information about the objects in the cfgSensorRedundancy group.
This group is applicable only for iDRAC on Rack and Tower Servers and not for iDRAC Enterprise on Blade Servers.
cfgSensorRedundancyIndex (Read Only)
Table 356. Details of cfgSensorRedundancyIndex
Description
Specifies index for the sensor redundancy group being read. Only power supply redundancy is supported.
Legal Values
1
Default
None
iDRAC Property Database Group and Object Descriptions 221