CLI Guide

• Critical
• Warning
•
Info
Valid examples of alert queries are:
• idrac.alert.all
• idrac.alert.audit
• idrac.alert.audit.lic
• idrac.alert.audit.warning
• idrac.alert.audit.lic.critical
Input • get — Displays the list of eventfilter settings.
• set — Configures the actions and notifications for a given eventfilter configuration.
• -i — Message ID for which the simulation is needed.
• -c — Alert category of the specific event filter.
• -a — The action that must be invoked when the event occurs. Valid values are none, powercycle, power
off, or systemreset.
• -n — The notification is sent when the event occurs. Valid values are all, snmp, ipmi, ws-events, oslog,
email, remotesyslog or none. You can append multiple notifications separated by a comma. You cannot
enter the values all or none with other notifications. If incorrect notification is specified along with other valid
notifications, the valid and invalid notification set is failed.
• -r — Event generation interval. This option is applicable only to the temperature statistics subcategory tmps.
You can use this option as a stand-alone or with -n and -a.
NOTE: If both event generation interval and notifications are configured and there is an error while
configuring the notifications, the event generation interval is not set. The valid values are 0–365. 0
disables the event generation.
Example • Display all available event filter configurations:
racadm eventfilters get -c idrac.alert.all
• Display eventfilter configurations for a specific category. For example, audit:
racadm eventfilters get -c idrac.alert.audit
• Display eventfilter configurations for a specific subcategory. For example, licensing under the audit category:
racadm eventfilters get -c idrac.alert.audit.lic
• Display eventfilter configurations for a specific severity. For example, warning under the audit category:
racadm eventfilters get -c idrac.alert.audit.warning
• Display eventfilter configurations for a specific severity and subcategory. For example, a severity of warning in
the subcategory licensing under audit category:
racadm eventfilters get -c idrac.alert.audit.lic.warning
• Clear all available alert settings:
racadm eventfilters set -c idrac.alert.all -a none -n none
• Configure using severity as a parameter. For example, all informational events in storage category are assigned
power off as action, and email and snmp as notifications:
racadm eventfilters set -c idrac.alert.storage.info -a poweroff -n
email,snmp
• Configure using subcategory as a parameter. For example, all configurations under the licensing subcategory in
the audit category are assigned power off as action and all notifications are enabled:
racadm eventfilters set -c idrac.alert.audit.lic -a poweroff -n all
54
RACADM Subcommand Details