Owners Manual

Steps

1. Loosen the two spring-loaded screws that secure the PCIe switch board to the system.

2. Press down the release latch.

The two levers are released.

3. Holding the two levers, pull the PCIe switch board out of the system.

Figure 46. Removing and installing the PCIe switch board

release latch 2. lever (2)

3. notch (4) 4. spring-loaded screw (2)

Next steps

Install the PCIe switch board.

Related tasks

Installing the PCIe switch board on page 57

Removing the system cover on page 34

Removing a cooling fan on page 52

Removing the cooling-fan cage on page 54

Removing a PCIe module on page 45

Installing the PCIe switch board

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the product.

NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified

service technicians.

1. Ensure that you read the Safety instructions on page 33.

2. Follow the procedure listed in Before working inside your system on page 33.

Installing and removing PowerEdge FX2/FX2s enclosure components