Owners Manual

Related tasks

Installing the control panel on page 77

Installing the control panel

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the product.

NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified

service technicians.

1. Ensure that you read the Safety instructions on page 33.

2. Follow the procedure listed in Before working inside your system on page 33.

3. Remove the control panel.

NOTE: You must remove the control panel to replace a faulty control panel.

Steps

1. Connect the control panel cable to the control panel.

2. Press the ZIF connector release latch into place.

3. Install the screw to secure the control panel cover to the control panel.

4. Align the screw holes on the control panel with the screw holes on the side of the system.

5. Install the two screws to secure the control panel to the side of the system.

6. Insert the control panel cable in the cable tube.

7. Align the screw holes on the cable tube with the screw holes on the side of the system.

8. Install the three screws to secure the cable tube to the side of the system.

Next steps

Follow the procedure listed in After working inside your system on page 33.

Related information

Removing the control panel on page 75

KVM panel

Removing the KVM panel

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform