Owners Manual
Table Of Contents
- Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Figure 59. Removing and installing the cable tubes
1.
screw on the KVM cover 2. KVM panel cover
3. Hex screw on the KVM panel (2) 4. KVM panel board
5. cable tube on the left side of the chassis 6. screws on the cable tubes (6)
7. tabs on the cable tubes 8. control panel cable
9. KVM panel cable 10. cable tube on the right side of the chassis
12. Push the KVM cable latch vertically up to disconnect the cable from the connector on the midplane.
13. Disconnect the control panel cable connector from the connector on the midplane.
Installing and removing PowerEdge FX2/FX2s enclosure components
71