Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
Figure 8. Enhanced network adapter isolation configuration
Table 8. Enhanced network adapter isolation configuration icon description
Icon Description
Network path
Node to pass-through module port mapping for the enhanced network
isolation configuration
In this configuration, each of the four nodes on an FM120x4 system is mapped to a single port on the pass-through module. The
network traffic from the nodes in the compute sled to the pass-through modules in the enclosure is routed through a network
switch that is embedded on the compute sled system board.
Figure 9. Node to pass-through module port mapping for the enhanced network isolation configuration
Table 9. pass-through module port mapping — FM120x4
FM120x4 Pass-through Module A1 (Top) Pass-through Module A2 (Bottom)
1 1a, 1b 1c, 1d
2 2a, 2b 2c, 2d
3 3a, 2b 3c, 3d
4 4a, 4b 4c, 4d
24 Pre-operating system management applications