Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
CAUTION: Never operate your system with the cooling shroud removed. The system may get overheated quickly,
resulting in shutdown of the system and loss of data.
1. Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
The sled is powered off when all the nodes are turned off.
2. Remove the sled from the enclosure.
3. Remove the cable cover from the cooling shroud.
4. Disconnect the SATA cables from the connectors on the system board.
NOTE: Note the routing of the SATA cables on the cooling shroud as you remove them from the system board. You
must route these cables properly when you replace them, to install the cable cover.
5. Loosen the two screws securing the cooling shroud to the chassis.
6. Lift the cooling shroud away from the chassis.
Figure 14. Removing and installing the cooling shroud
a. cooling shroud
b. screws (2)
Installing the cooling shroud
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Lower the cooling shroud into the sled chassis and align the screw holes on the cooling shroud with the screw holes on the
sled chassis.
2. Tighten the two screws to secure the shroud to the chassis.
3. Route the SATA cables on the cooling shroud, and connect the SATA cables to the system board connectors.
4. Install the cable cover on the cooling shroud.
5. Install the sled in the enclosure.
6. Turn on the sled.
30
Installing sled components