Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
Figure 19. Hard-drive/SSD bay numbering — 2.5 inch hard-drive/SSD system
Table 12. Hard drive/SSD to node assignment — 2.5 inch hard-drive/SSD configuration
Hard-Drive/SSD Bay Node
A-0 A
B-0 B
C-0 C
D-0 D
Figure 20. SSD bay numbering — 1.8 inch SSD system
Table 13. Hard drive/SSD to node assignment — 1.8 inch SSD configuration
Hard-Drive/SSD Bay Node
A-0 A
A-1 A
B-0 B
B-1 B
C-0 C
C-1 C
D-0 D
D-1 D
Removing a hard drive/SSD
NOTE:
The 2.5 inch hard-drive/SSD configuration supports four warm-swap hard-drives/SSDs. Each hard-drive/SSD is
assigned to a specific node, and the node to which it is assigned must be turned off before servicing the hard-drive/SSD.
NOTE: The 1.8 inch SSDs are hot-swap. Not all operating systems support hot-swap drive installation. See the
documentation supplied with your operating system.
1. To remove a 2.5 inch hard-drive/SSD, turn off the node to which the hard-drive is assigned, using the iDRAC.
2. Take the hard drive/SSD offline and wait until the hard-drive/SSD indicators on the drive carrier are off.
The drive is ready for removal.
Installing sled components
35