Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
NOTE: See your operating system documentation for more information on taking the drive offline.
3. Open the hard-drive/SSD carrier handle to release the drive.
4. Slide the hard drive/SSD out until it is free of the drive bay.
If you are permanently removing the hard drive/SSD, install a drive blank.
Figure 21. Removing and installing a 2.5 inch hard drive/SSD
1.
release button 2. hard drive/SSD
3. hard-drive/SSD connector (on backplane) 4. hard-drive/SSD carrier handle
Figure 22. Removing and installing a 1.8 inch SSD
1.
SSD connector (on backplane) 2. SSD
3. SSD carrier handle 4. release button
Installing a hard drive/SSD
CAUTION:
When a replacement hot-swap hard drive/SSD is installed and the sled is powered on, the drive
automatically begins to rebuild. Make absolutely sure that the replacement hard drive/SSD is blank or contains
36 Installing sled components