Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
Figure 23. Removing and installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
1. hard drive/SSD 2. screw holes (4)
3. hard-drive/SSD carrier 4. screws (4)
Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
1. Insert the hard drive/SSD into the hard-drive/SSD carrier with the connector end of the drive at the back of the carrier.
2. From the back of the carrier, slide the drive into the carrier.
3. Align the screw holes on the hard drive/SSD with the holes on the hard-drive/SSD carrier.
CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws.
4. Install the four screws to secure the hard drive/SSD to the hard-drive/SSD carrier.
Removing a 1.8 inch SSD from the SSD carrier
CAUTION:
To avoid damaging the SSD or the SSD carrier, do not use excessive force while removing the SSD
from the SSD carrier.
1. Pull outward on the edges of the SSD carrier in the direction of the arrows marked on the SSD carrier and disengage the
SSD from the carrier.
2. Slide the SSD out of the SSD carrier.
38
Installing sled components