Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
b. memory modules
c. cable cover
d. cooling shroud
e. hard-drive/SSD backplane
f. system board
4. Disconnect the control-panel cable from the control-panel board.
5. Remove the two screws securing the control-panel assembly to the chassis.
6. Slide the control-panel assembly out and away from the chassis.
7. Remove the three screws securing the control-panel board to the control-panel bracket, and lift the control-panel board
away from the bracket.
Figure 30. Removing and installing the control panel
1.
control-panel bracket 2. control-panel cable connector
3. control-panel board 4. sled
5. screws (2)
Installing the control panel
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Align the screw holes on the control-panel board with the screw holes on the control-panel bracket.
2. Install the three screws to secure the control-panel board to the control-panel bracket.
3. Connect the control-panel cable to the connector on the control-panel board.
4. Position the control-panel assembly so that the USB connector and USB select button face the front of the system.
5. Slide the control-panel assembly into the chassis, until the USB select button and connector align with the slots on the
chassis.
The screw holes on the control-panel bracket align with the screw holes on the chassis.
46
Installing sled components