Owners Manual
Table Of Contents
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
Expanded
operating
temperature
Specifications
NOTE: Outside the standard operating temperature (10 °C to 35 °C), the system can operate down
to –5 °C or up to 45 °C for a maximum of 1% of its annual operating hours.
For temperatures between 40 °C and 45 °C, de-rate maximum allowable dry bulb temperature by 1 °C
per 125 m above 950 m (1 °F per 228 ft).
Expanded
operating
temperature
restrictions
Do not perform a cold startup below 5 °C.
Environmental specifications
NOTE: For additional information about environmental measurements for specific system configurations, see Dell.com/
environmental_datasheets.
Temperature Specifications
Maximum
Temperature
Gradient
(Operating and
Storage)
20 °C/h (36 °F/h)
Storage
Temperature
Limits
–40 °C to 65 °C (–40 °F to 149 °F)
Temperature
(Continuous
Operation)
Specifications
Temperature
Ranges (for
altitude less than
950 m or 3117 ft)
10 °C to 40 °C (50 °F to 104 °F) with no direct sunlight on the equipment.
Humidity
Percentage
Range
10% to 80% Relative Humidity with 29 °C (84.2 °F) maximum dew point.
Relative
Humidity
Specifications
Storage 5% to 95% RH with 33 °C (91 °F) maximum dew point. Atmosphere must be non-condensing at all times.
Maximum
Vibration
Specifications
Operating 0.26 G
rms
at 5 Hz to 350 Hz (all operation orientations).
Storage 1.87 G
rms
at 10 Hz to 500 Hz for 15 min (all six sides tested).
Maximum
Shock
Specifications
Operating One shock pulse in the positive z axis of 31 G for 2.6 ms in all operational orientations.
58 Technical specifications