Reference Guide

108 | FIP Snooping
www.dell.com | support.dell.com
Debugging FIP Snooping
To enable debug messages for FIP snooping events, enter the debug fip-snooping command.
To turn off debugging event messages, enter the
no debug fip-snooping command.
Task Command Command Mode
Enable FIP snooping debugging on for all or a
specified event type, where:
all enables all debugging options.
acl enables debugging only for ACL-specific events.
error enables debugging only for error conditions.
ifm enables debugging only for IFM events.
info enables debugging only for information events.
ipc enables debugging only for IPC events.
rx enables debugging only for incoming packet
traffic.
debug fip-snooping [all | acl | error |
ifm | info | ipc | rx]
EXEC PRIVILEGE