Reference Guide

120 | Interfaces
www.dell.com | support.dell.com
Use the show ip interfaces brief command in EXEC Privilege mode to view which interfaces are enabled for
Layer 3 data transmission. In Figure 10-2, the TenGigabitEthernet interface 1/5 is in Layer 3 mode because
an IP address has been assigned to it and the interface’s status is operationally up.
Figure 10-2. show ip interfaces brief Command Example (Partial)
Use the show interfaces configured command in EXEC Privilege mode to view only configured interfaces.
To determine which physical interfaces are available, use the
show running-config command in EXEC mode.
This command displays all physical interfaces available on the switch (Figure 10-3).
Figure 10-3. show running-config Command Example (Partial)
FTOS#show ip interface brief
Interface IP-Address OK Method Status Protocol
TenGigabitEthernet 1/1 unassigned NO None up down
TenGigabitEthernet 1/2 unassigned NO None up down
TenGigabitEthernet 1/3 unassigned NO None up down
TenGigabitEthernet 1/4 unassigned NO None up down
TenGigabitEthernet 1/5 unassigned YES None up up
TenGigabitEthernet 1/6 unassigned NO None up down
TenGigabitEthernet 1/7 unassigned NO None up down
TenGigabitEthernet 1/8 unassigned NO None up down
TenGigabitEthernet 1/9 unassigned NO None up down
--More--
FTOS#show running config
Current Configuration ...
! Version E8-3-17-38
! Last configuration change at Tue Jul 24 20:48:55 2012 by default
!
boot system stack-unit 1 primary tftp://10.11.9.21/dv-m1000e-2-b2
boot system stack-unit 1 default system: A:
boot system gateway 10.11.209.62
!
redundancy auto-synchronize full
!
service timestamps log datetime
!
hostname FTOS
!
username root password 7 d7acc8a1dcd4f698 privilege 15
mac-address-table aging-time 300
!
stack-unit 1 provision I/O-Aggregator
!
stack-unit 1 port 33 portmode quad
!
stack-unit 1 port 37 portmode quad
--More--