Reference Guide

124 | Interfaces
www.dell.com | support.dell.com
To display the configuration for a given port, use the show interface command from EXEC Privilege mode
(Figure 10-5).
To display the routing table for a given port, use the
show ip route command from EXEC Privilege mode.
Figure 10-5. Viewing Management Routes
FTOS#show interface tengigabit 0/46
TenGigabitEthernet 0/4 is up, line protocol is up
Port is part of Port-channel 1
Hardware is DellForce10Eth, address is 00:01:e8:e1:e1:c1
Current address is 00:01:e8:e1:e1:c1
Server Port AdminState is Up
Pluggable media not present
Interface index is 34935553
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG1330001e8e1e1c1
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:10:18
Queueing strategy: fifo
Input Statistics:
202 packets, 24015 bytes
103 64-byte pkts, 20 over 64-byte pkts, 52 over 127-byte pkts
27 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
163 Multicasts, 39 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
356 packets, 80597 bytes, 0 underruns
36 64-byte pkts, 34 over 64-byte pkts, 44 over 127-byte pkts
242 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
271 Multicasts, 85 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:10:23
FTOS#