Reference Guide

Interfaces | 131
Adding an Interface to an Untagged VLAN
To move an untagged interfaces from the default VLAN to another VLAN, use the vlan untagged command
as shown in Figure 10-10.
Figure 10-10. Moving an Untagged Interface to Another VLAN
Port Channel Interfaces
On an Aggregator, port channels are auto-configured as follows:
• All 10GbE uplink interfaces (ports 33 to 56) are auto-configured to belong to the same 10GbE port
channel (LAG 128).
• Server-facing interfaces (ports 1 to 32) auto-configure in LAGs (1 to 127) according to the NIC
teaming configuration on the connected servers.
Port channel interfaces support link aggregation, as described in IEEE Standard 802.3ad. .
Note: A port channel may also be referred to as a link aggregation group (LAG).
FTOS(conf)# interface tengigabit 0/16
FTOS(conf-if-te-0/16)# vlan untagged 4
FTOS(conf-if-te-0/16)# exit
FTOS(conf)# exit
FTOS#00:23:49: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
FTOS# show vlan id 4
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary,
C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged, C - CMC tagged
NUM Status Description Q Ports
4 Active U Po1(Te 0/16)
T Po128(Te 0/33,39,51,56)
T Te 0/1-15,17-32
FTOS#
Enter the vlan untagged command to add interface Te 0/16
as an untagged member of VLAN 4.
Enter the show vlan command to verify that interface Te 0/16
is an untagged member of VLAN 4.