Reference Guide

Interfaces | 145
Figure 10-21 shows the auto-negotiation options.
Figure 10-21. Setting Auto-Negotiation Options
Viewing Interface Information
Displaying Non-Default Configurations
The show [ip | running-config] interfaces configured command allows you to display only interfaces that
have non-default configurations are displayed.
Figure 10-22 shows the possible
show commands that have the configured keyword available.
Figure 10-22. show Commands with configured Keyword Examples
FTOS(conf)# int tengig 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
FTOS(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
FTOS(conf-if-autoneg)#
FTOS#show interfaces configured
FTOS#show interfaces tengigabitEthernet 0 configured
FTOS#show ip interface configured
FTOS#show ip interface tengigabitEthernet 1 configured
FTOS#show ip interface brief configured
FTOS#show running-config interfaces configured
FTOS#show running-config interface tengigabitEthernet 1 configured