Reference Guide

Stacking | 211

Resetting a Unit on a Stack

Use the following reset commands to reload any of the member units or the standby in a stack. If you try to

reset the stack master, an error message is displayed:

Reset of master unit is not allowed.

Removing an Aggregator from a Stack and Restoring Quad

Mode

To remove an Aggregator from a stack and return the 40GbE stacking ports to 4x10GbE quad mode:

When the reload completes, the base-module ports comes up in 4x10GbE (quad) mode. The switch

functions in standalone mode but retains the running and startup configuration that was last synchronized

by the master switch while it operated as a stack unit.

Task Command Syntax Command Mode

Reload a stack unit from the master switch

reset stack-unit unit-number

EXEC Privilege

Reset a stack-unit when the unit is in a problem state.

reset stack-unit unit-number

hard

EXEC Privilege

Step Task Command Syntax Command Mode

1 Disconnect the stacking cables from the unit. The unit can be powered on or off and can be online or offline..

2 Log on to the CLI and enter Global Configuration mode.

Password: *****

FTOS> enable

FTOS# configure

---

3 Configure the Aggregator to operate in standalone mode.

stack-unit 0 iom-mode

standalone

CONFIGURATION

4 Log on to the CLI and reboot each switch, one after

another, in as short a time as possible.

reload

EXEC PRIVILEGE