Reference Guide

Configuration Fundamentals | 11
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. Table 3-1 lists the CLI mode, its prompt, and
information about how to access and exit this CLI mode. You must move linearly through the command
modes, with the exception of the
end command, which takes you directly to EXEC Privilege mode and the
exit command moves you up one command mode level.
Note: Sub-CONFIGURATION modes all have the letters “conf” in the prompt with additional modifiers to
identify the mode and slot/port information. These are shown in Table 3-1.
Table 3-1. FTOS Command Modes
CLI Command Mode Prompt
Access Command
EXEC
FTOS>
Access the router through the console or Telnet.
EXEC Privilege
FTOS# • From EXEC mode, enter the command enable.
• From any other mode, enter the command end.
CONFIGURATION
FTOS(conf)# • From EXEC privilege mode, enter the command
configure.
• From every mode except EXEC and EXEC
Privilege, enter the command exit.
Note: Access the following modes from CONFIGURATION mode:
INTERFACE modes
10 Gigabit Ethernet
Interface
FTOS(conf-if-te-0/1)
#
interface
Interface Range
FTOS(conf-if-range)
#
interface
Management Ethernet
Interface
FTOS(conf-if-ma-0/0)
#
interface
Monitor Session FTOS(conf-mon-sess) monitor session
IP COMMUNITY-LIST FTOS(conf-community-list)# ip community-list
LINE
CONSOLE FTOS(conf-line-console)#
line
VIRTUAL TERMINAL FTOS(conf-line-vty)#
line