Reference Guide

36 | Getting Started
www.dell.com | support.dell.com
File System Management
The Dell Force10 system can use the internal Flash, USB Flash, or remote devices to store files. The
system stores files on the internal Flash by default, but you can configure it to store files elsewhere.
To view file system information:
The output of the
show file-systems command (Figure 4-13) shows the total capacity, amount of free
memory, file structure, media type, and read/write privileges for each storage device in use.
Figure 4-13. show file-systems Command Example
You can change the default file system so that file management commands apply to a particular device or
memory.
To change the default storage location:
You can change the default storage location to the USB Flash (Figure 4-14). File management commands
then apply to the USB Flash rather than the internal Flash.
Task Command Syntax Command Mode
View information about each file system.
show file-systems
EXEC Privilege
Task Command Syntax Command Mode
Change the default directory.
cd directory
EXEC Privilege
FTOS#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
2143281152 836878336 FAT32 USERFLASH rw flash:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
FTOS#