Concept Guide

52 Dell 8/4Gbps FC SAN Module Administrator’s Guide
53-1001345-01
portCfgShow
B
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to “Understanding Virtual Fabric restrictions” on page 32 snf “Understanding
Admin Domain restrictions” on page 33 for details.
Operands This command has the following operand:
license Specifies the license key to be installed. This operand is required.
Examples To add a license key to the switch:
switch:admin> licenseadd DXXtN3LmRSMWCSW3XmfSBPfrWKLZ3HMTN73rP9GANJMA
adding license-key [DXXtN3LmRSMWCSW3XmfSBPfrWKLZ3HMTN73rP9GANJMA]
portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [slot/]port
portcfgshow option [slot/] [arguments] [optional_arguments]
Description Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are
supported on all platforms.
“Non-GbE port displays” on page 52
If no operand is specified, this command displays port configuration settings for all ports on a
switch, except Gigabit Ethernet (GbE) ports.
Non-GbE port displays
The following information is displayed when the command is issued for all ports or for a specific
port:
Area Number Displays the port area number. This field is displayed only when portCfgShow
is executed for a specific port.
Speed Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4,
or 8 Gbps. This value is set by the portCfgSpeed command.
Fill Word Displays 0(Idle-Idle) or 1(arbff-arbff). This parameter is set by the
portcfgFillword command.
AL_PA Offset 13 Displays (...) or OFF when the arbitrated loop physical address (AL_PA) on the
port is configured to use a 0x0 AL_PA address (default). Displays ON when
the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa
command.
Trunk Port Displays ON when port is set for trunking. Displays (..) or OFF when trunking is
disabled on the port. This value is set by the portCfgTrunkPort command.
Long Distance Displays (..) or OFF when long distance mode is off; otherwise, displays long
distance levels as follows:
LE The link is up to 10 km.