Concept Guide

64 Dell 8/4Gbps FC SAN Module Administrator’s Guide
53-1001345-01
supportShow
B
iscsi iSCSI group commands, disabled by default.
fcip FCIP group commands, disabled by default.
ag Access Gateway group commands, disabled by default.
dce_hsl DCE group commands, enabled by default.
crypto Encryption group commands, disabled by default.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to “Understanding Virtual Fabric restrictions” on page 32 and “Understanding
Admin Domain restrictions” on page 33 for details.
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may
change without notice.
Operands This command has the following operands:
slotnumber On bladed systems only, specifies a slot number, followed by a slash (/).
portnumber1-portnumber2
Specifies the range of ports for which to display supportShow information. If a
port range is not specified, the command displays information for all ports.
lines Specifies the number of lines for the portLogDump output. This parameter is
valid only with the slotnumber/portnumber parameters.
Examples To display debugging information:
switch:admin> supportshow
VF
======================
Date:
Wed Oct 22 09:31:41 UTC 2008
Time Zone:
Time Zone Hour Offset: 0
Time Zone Minute Offset: 0
Version:
Kernel: 2.6.14.2
Fabric OS: v6.2.0_main_bld26
Made on: Mon Oct 20 10:10:30 2008
Flash: Mon Oct 20 16:04:18 2008
BootProm: 1.0.6
supportshow groups enabled:
os enabled
exception enabled
port enabled
fabric enabled
services enabled
security enabled
network enabled
portlog enabled
system enabled
extend disabled
filter disabled